Monday, September 17, 2012

Back to work

Ok next pics of this weeks work,
After fitting the bronze fastening to the rudder, I decided get the tie coat primer on and make the boat look like a boat again.
 Began on Starb side
Then port
It realy did the trick. Now the Engine.
After a lot of de greasing, chipping, wire brushing, washing and rust treatment, the primer was put on.
And afterwards the new color paint job was applied.

Tonight Sunday, after overhauling the coupling and heat exchanger, also a little detailing, the engine is ready to go back into position. So I hope next week I can say its running again.

No comments:

Post a Comment